260 results in 0.0139 seconds.
-
Exhaust Bracket 676857 (needed?)
So I have this exhaust bracket for my '54 3R5 truck. The bracket was made to attach to the bell housing and hold the exhaust pipe coming off the header....Last edited by Ctorrance; 12-06-2025, 02:05 PM. -
Another Question About my 1956 Commander 4 Door Sedan
I don't know if i should create 1 thread about the same car on here which contains all my questions, or if it's OK to ask various questions in different... -
R3 repro exhaust manifolds - ceramic coating
I have a set of the repro R3 exhaust manifolds I'm planning to put on my 289 motor currently in progress, if I ever get it done. I'm not big on the factory...
Last edited by M-Webb; 09-30-2025, 05:28 PM. -
Please confirm no heat riser on this 289 V8
I've never seen one of the Studebaker heat risers, or what my parts book labels a `Valve Assembly Heater`, in person. But I'm pretty sure these photos... -
Compatible part years for a '54 3R5-12 truck
Hi All, Picked up my '54 last year and I am in the process of going thru everything for a near complete restoration. She's already in good shape but... -
Tailpipe
My 63 Lark has a really small tailpipe (1 1/2 inch diameter). Is this the correct size for my engine (289) ? Not sure what engine originally came... -
Heat riser or Electronic Choke-doo-thingy..?
As you can see in the picture, the heat riser from our M5 cleaned up well.
The casualties—the flange is split into two and the spring snapped...Last edited by Josephine; 04-15-2025, 01:12 PM. -
Intake Manifold-Exhaust Manifold—oh my..!
Hello folks...
After rebuilding just about every system in Josephine (a 1941 M5) I finally installed a spanking new Flowmaster muffler and... -
Late Stude Avanti crosover pipes...............
How many with '64 Avantis have kept the crossover pipes, as opposed to using the former straight through examples?? -
bsrosell started a topic Exhaust: V8 exhaust pipe nuts; not supposed to torque brass? Go back to original steel nuts?in Tech TalkV8 exhaust pipe nuts; not supposed to torque brass? Go back to original steel nuts?
I had to remove my right exhaust pipe from manifold (57 Golden Hawk, 289) last fall, and happened to read a post here that I should have used brass nuts... -
Exhaust stink
I will tell you a story that most likely you will not believe. Remember I have previously mentioned that for many many years I have been experiencing... -
Removing Welded Exhaust Tips
Trying to remove these crappy chrome pea shooters from my ‘62 GT to install stock deflectors.
I don’t want to damage the pipe and need... -
57 to 59 hawk exhaust size.
Here I go again. I’m going to order AC2840 exhaust tips from SI.
but before I do. I would like to know what size 1957 to 1964 hawk rear exhaust... -
V8 exhaust flange replacement. Cross reference!
I am getting a new exhaust at a local shop close to me.
Since the exhaust flange is welded to the pipe. Does anyone know what vehicle would be...
