Engine stalls when put in gear

[Scarylarry]

Engine runs fine in neutral, but dies when put in gear. Could it be a stuck torque converter? How do I remedy that if it is? I have a 57 commander with...

[cosmo556]

I am assembling the chassis on my 57 sedan and I have been setting up the pedals. This question should apply to all models with through the floor pedals....

[Rick P]

I finally found a 2004R at a local transmission shop that they are willing to build for me for my 1962 Hawk. I will be replacing my Dana 27 with 3.73...

[cosmo556]

I am restifying my '57 Commander sedan and am using an R2 setup with a T10 4 speed from an R2 Lark. I need the clutch linkage cross shaft support bracket...

[JamesWat1979]

Hello all,

I have been browsing this forum occasionally as a non member for quite some time but just recently joined up in hopes of getting...

[JohnHenne]

Parts book calls it the "release shaft return spring" and it seems to mount around the shaft and bears on one of the throw out forks. I can't...

[hawkbill47]

Finding an o-ring to replace the "grease seal" p/n 527280 for a 289 clutch shaft has been difficult. However I located a suitable replacement...

[jackb]

I'm in the process of sealing the engine in my 259. One of the issues concerns the torque converter(TC). I know the screws from flex plate to TC are...

[hawkbill47]

I am curious as to why the bell housing on my 289 has provisions for clutch shaft lubrication on the drivers side (zerk fitting) but only a closed cavity...

[Dwight FitzSimons]

My R3 (B69) short block is currently at a highly respected engine builder's shop to be gone through after a long sleep. The first issue is what pressure...

[Henry]

I need to remove my clutch pedal spring, under the dash, of my 63 Lark, and no amount of what strength I have left can budge it off the pedal perch. ...

[Joe Lange]

I have just about reached the end of my rope with my 1960 Lark. V8, 3 speed, no overdrive, 74000 miles. The car is Stock.
Decided about 4 months...

[BRUCESTUDE]

For my M16 big six/T9 I need to borrow or rent a clutch alignment tool, of course I’ll reimburse for shipping!

When the engine was out...

[Tom Mountain]

clutch is slipping, what adjustments will remedy this problem....Thank You

[Rafe Hollister]

I'm ready to install my BellHousing and T5 trans on my 259/289 '56 PowerHawk. I'm using what I think is the original Bellhousing. It is aligned to 2 thousandths....