64 hardtop vent window assy

[Warren Webb]

While driving my 64 Daytona hardtop the other day I noticed the top pivot for the vent window was broken. Studebaker International lists a right side...

[Hawklover]

To those that own Avantis, take a look at the Studebaker name plate, the parts book claims the name plate is secured with (4) G4411251 6-32 stamped nuts...

[Claybreaker 144]

My 53 Commander body had some pinholes in the rear weatherstrip channel and a couple of rust holes in the lower part of the panel. I had to replace the...

[Jeff T.]

Good afternoon,

Earlier this week I posted about tweeking a twisted hardtop door which I am in the process of repairing.

But......

[morganmotors]

Will a window regulator from a 1962 GT Hawk fit a 1957 Golden Hawk. The parts book indicates the same regulator is used for 1959 to 1963 C and K body...

[Jeff T.]

Good afternoon,

A couple of years ago, I discovered that I original right door on my 62 Lark hardtop was too rusty to fix, it's steel seemed...

[Bruce S]

63 gt hawk: I replaced the striker on the drivers side because it was broken. I installed the new one identical to the old one but unless I apply slight...

[bills57hawk]

I need to replace a broken top window pivot on the front window vent for a 57 Hawk. I ordered the pivot from Stude International but they no longer carry...

[blanconm]

has anyone applied '62 daytona side trim to a '62 regal HT? if so, how did it fit?
thanks

[Tired iron]

After lots of sheet metal cut and replace, a week of filler and sanding, and several days of blocking primer, I get to shoot paint tomorrow on my 56j...

[poweroptions]

I am buttoning up my total restoration on the 54 Starlight, Looks like I will be installing the windshield with a helper. I read the process outlined...

[Tired iron]

I've got a 56j Goldenhawk that I'm finishing up bodywork on. I've got a trunk here that I think is a 57. What are all the little holes for? I'm guessing...

[jadiggle3354]

63 Lark: trying to remove the driver side vent window; I found the two bolts that attach the vent window to the door, but the manual shows a third bolt...

[bsrosell]

Hi,
Body is out for sandblasting! Was going to buy new “set” of the reinforced rubber shims to mount body to the frame.

Does anyone...

[lelshaddai]

I am working on refinishing the port window frames on a 53 Commander. Do I need to grind off the pop rivets and take it apart to insert the new rubber?...