500 results in 0.0324 seconds.
-
Antifreeze during storage
So my Hawk sat in a guy’s yard in California for the last 30 years, so it probably never got real cold. When I got it in April, I looked in the radiator... -
Slot in the plenum chamber
Can any one tell us the use for the slot cut into the upper plenum on the right hand side. I have seen a rubber cover on some but what purpose does it... -
1951 6 cyl cooling questions
Hello all and thank you in advance. Picture is from my restored 51 coupe with 500 miles. I've only been driving the car four months so operating experience... -
-
Has anyone tried this aluminum truck radiator?
My truck was running and cooling fine with a Lark radiator, but someone had cut the top out of the radiator support. I replaced the support and used a... -
Radiator hose clamps in 54
What is the correct style of radiator hose clamps used in 54. I bought tower clamps. Now wondering if they are right. TYLast edited by poweroptions; 07-15-2020, 09:58 AM. -
53/54 CK radiator interchange
I have a 53 coupe that the prier owner installed a 350 crate motor into. 350 Automatic. He also installed a custom made 5 row copper radiator with electric... -
Wanting to add A/C to a 1959 Lark VI.
I would like to add A/C to our 1959 Lark but I am wondering how did the dealers do this with the little six and a single groove crank pulley. I've found... -
Minor Problems on First Start-up, Heater control valve
My First Start-up after 2 1/2 months went well!! I listened to advise on an earlier post and stuck to the Engine and Engine compartment, although I was... -
Engine Temp
My 55 Commander 259 after 3 years of fairly good service has suddenly started to run hot, on the high side of the white arc on the guage. Still shows... -
‘52 Champion water pump rebuild
How difficult is it to rebuild the water pump. I noticed some noise from the front of the engine and there is some play in the fan. Ideas?
thanks... -
water temp. sending unit.
were is the water temp. dending unit on a 64 crusier 289 v/8 engine located? -
AC Drain line
I’m working on getting my AC going on my 64 Cruiser. It is a factory setup on a non-factory AC car that the prior owner installed. I have everything... -
Factory AC Conversion to R134a Kits?
All,
My 1964 GT Hawk has factory AC. We know it has no R12 refrigerant and the hoses are shot and need to be replaced. The box inside the... -
Fan orientation - 289?
I’m likely overthinking this, but the HD 6-blade cooling fan I installed from S-I seems to pushing air forward through the rad, not pulling the air...
