how hard to turn upper caster/camber pin, and pump grease in it?

[bsrosell]

A bit of panic this weekend. Sorry for long post. Context.

I've been trying to figure out my steering (rebuilt Saginaw power steering unit,...

[bsrosell]

Hi, two questions about setting the camber/caster on my '57 GHawk.
1) the shop manual doesn't indicate if car should be on a hoist or sitting...

[Commander Eddie]

A little while back I posted that I was having some repairs done on my '55 President Sedan to replace worn parts. I was asked to report on how these repairs...

[royvaldez]

I used to have a really good way of taking the front coils off a older studebaker. I cant find the information in my office. It used a Floor Jack and...

[ecarbonneau]

Hi,

first time on the site. Getting ready to install a Mustang IFS 2 front end suspension on my 1949 2R5.
Anyone knows what is the...

[jostanton1]

I removed a small bracket during the dismantling and restoration of my 64 GT. The car is finished and I was going through a parts box and found this...

[Cus63]

Hello,
My '61 Hawk sat idle for many years around 20 , with no engine. The front coil springs had stretched out during that time, I now have all...

[airmanjwt]

Is there a simple way to replace the control arm bushings without dismantling the entire front end on a 62 GT? Both the upper and lower bushings have...

[Mike Van Veghten]

For all you that want to weld on a 'kit" front suspension.

Here's some good info about suspension (mostly front). You NEED to watch...

[MCCAB1]

I am trying to find the right MOOG front coil spring part number for a V8 1963 Daytona....

[Dan White]

Finally, progress on installing a C4 suspension in my '58 C Cab. Everything is tacked in and need to do some measurements for wheels and tires before...

[64studeavanti]

How bad can the wear on the pivot arms be and still be serviceable? I know that they really are not supposed to pivot, but this one looks very rough....

[ChampCouple]

So I temporarily put tires and wheels on the front end of my frame...... and not sure how much curve the front springs should have. No transmission or...

[Noxnabaker]

I have this idea that to set the camber one of the 4 joints for upper & lower A-arms ought to have an exentric bolt, can sombody tell me wich one...

[joe bailey]

I've got a 53 commander 350 sbc 700r4 trans I've got 600 lb springs with mustang 2 suspenion way too stiff has anybody gone thur the trial and error of...