All,
I am putting together a 55 engine and transmission. 3sp OD and a 259. I have almost everything done but when I when to out the trans into the engine I noticed that it doesn't sit inside the large hole that looks like it should.
Can I just get this machined bigger? I have another bell housing but the holes for the trans don't line up. Any help would be appreciated, I'm trying to get this thing done for my wedding at the end of August and my back is really getting up against that wall.
TIA!
Jared
I am putting together a 55 engine and transmission. 3sp OD and a 259. I have almost everything done but when I when to out the trans into the engine I noticed that it doesn't sit inside the large hole that looks like it should.
Can I just get this machined bigger? I have another bell housing but the holes for the trans don't line up. Any help would be appreciated, I'm trying to get this thing done for my wedding at the end of August and my back is really getting up against that wall.
TIA!
Jared
Comment