On my Stude. V-8 5-speed swap. I've bushed the Stude. release bearing according to all the info I've been able to find, so it now fits the T-5 trans. The two clutch release bearing levers on the Stude. truck bellhousing that I'm using don't point straight up as I'm assuming they should. How verticle should they be using a Stude. bellhousing,release bearing and clutch assembly? I'm asking so I can determine if I need to notch the front bearing retainer. Dclewallen
Darryl C. Lewallen
Darryl C. Lewallen
Comment