Read about this in Chuck Lampmans' book. Since I am rebuilding my Packard engine, thought I'd do this to the cylinder heads--grind the area in the combustion chamber immediately around the plug tip down just enough so as to be able to use 3/8 reach plugs instead of 7/16". Has anyone here done this, and was it beneficial? What plug number do you use, then? Thanks for any help on this subject.
Thank you for visiting the SDC Forum, a service of the Studebaker Drivers Club, Inc., an International non-profit organization dedicated to the promotion and preservation of Studebaker automobiles.
Our Forum is free to use, but in order to join the discussion boards you will first need to register.
Read our Policies and Terms Of Service here.