Was there a running change in the location of the vent /overflow lines? The connections on my tank are not in the same place as shown in the Bob Johnstone's web page, especially the vent connection which is dead center on my tank, instead of to the side on his photo.
Further, the vent line runs up into the left pillar, then back down and through a hole in the tank floor, instead of the right wheel well as described on that page. My issue is gas fumes in the cabin that I cannot locate. Should I re-route this line?
Further, the vent line runs up into the left pillar, then back down and through a hole in the tank floor, instead of the right wheel well as described on that page. My issue is gas fumes in the cabin that I cannot locate. Should I re-route this line?
Comment