!962 Hawk Leaf Spring Bushings

[chet445]

I am replacing the leaf spring bushings with some manufactured from Delrin. I need to line the bolt openings with metal tubing; the bushings were from...

[Lyle C]

I am looking for a frame swap on 1952 2r5 pickup with a 112 inch wheel base. I would like to see ps,pb plus a bigger engine. The frame swap is to support...

[JoeHall]

I am preparing to replace the rear shocks on the 62GT, and do not want to use Gabriels again. I dug up an old thread here that says Japanese KYB, number...

[23 cratae]

heres a little thing to share .. i found this while tweaking my front brake.. - this arm is on the drivers side of the car ,, so couldve had some nasty...

[Al Kurz]

All. I have a '61 Hawk 4 spd. Years ago the springs were sagging and I had them re arc'ed. Since then, my rear ends sits about 2" high. I want...

[HawkBuilder]

In 66 did they use the same gauge steel on the frames for V8s and 6 cyls? Or did the 6 cyls have a lighter gauge? I know in the 50s 6 cyls had a lighter...

[Mridgway]

While replacing the front springs on my 1956 Studebaker Power Hawk, the left upper control arm inner pin mounting in the crossmember/frame broke out around...

[ChampCouple]

The two rear leaf spring hangers on my 62 Champ frame are positioned at different heights on the frame. Is it suppose to be that way?

...

[JoeHall]

I have a total front end rebuild pending for the 62GT, including upper & lower 'A' arm rubber bushings (last replaced Oct 2011). Also, as of yesterday,...

[62champ]

Quick question about front leaf spring question.

Have a family member working of a 1950 2R5 and had a question about front leaf springs....

[chet445]

In my Hawk rebuild I replaced all springs. I noticed that the forward end of the leaf springs have worked their way such that each now rests against the...

[T-CAB]

I am ready to install the rear bumper brackets on my '64 Lark. Have forgot what side of the frame rails they go on. There are 3 options for the right...

[Waratah]

Hi All
I am in the early stages of restoring my 55 coupe, so this will be the first of many questions
The new spring clips i have look...

[mch]

I am wondering how many zerc fittings should be on my 63 GT Hawk, 64 Super Hawk and 64 Avanti R2. While service is yearly; mileage or not, I tend to...

[ChampCouple]

My '62 Champ frame has a small crack behind the transmission cross member and the steel plate for the clutch shaft. There is really no room to do anything...