Any distributors that allow EFI ECU to control timing?

[cochranjd]

Hello everyone -

Over the next few years, I'm planning to make the swap from a carb to EFI, most likely using the Holley Sniper system, in...

[Flthdchamp]

Hi,
today I was changing the distributor cap and noticed that the cap I was removing was slightly different than the replacement. The old cap had...

[bezhawk]

So, I went to start a Stude I've been working on, and it didn't start. Ok...check for fuel....yep. Check spark. Nope. Getting power to the coil...ok....

[JohnAustin]

The ignition switch is loose in my 1954 Studebaker Pickup - 3/4 Ton which has as Lark dashboard. Could it be the small chrome bezzle with "J-slots"...

[Flthdchamp]

Hello all,
I finally got around to replacing the incorrect rotor on my 50 champion IAT distributor with the correct one. As expected, the incorrect...

[Ron Dame]

I want to retard my timing a bit, but the vacuum canister is hitting the generator (OHV6) so I want to move the plug wires on the cap and adjust from...

[Flthdchamp]

Hello, I have a late 50 champion with the IAT distributor. I attached a pic below. The rotor looks incorrect. In fact it doesn’t look right for an early...

[mw2013]

ford is 9 bucks anyone have a part number?
stude is 20 bucks
10 bucks for fast food
if it works

thanks

[mw2013]

Lark stopped starting, need to check it out further and jump the solenoid, is there a fuse or breaker somewhere? lights work, idiot lights up, switch...

[mw2013]

I am having trouble with autozone, I got this information off the interchange sheet and some positively ID a Dist cap and rotor for my car?
...

[Jersey Hawk]

studebaker international has an new electronic ignition distributor setup ,how are they working out for those that have them? or can anyone recommend...

[wuga]

This is the starter magnetic switch used on a 259 V8 in a 1962 Lark. It bolts to the fender well on the drivers side. A cable runs from...

[shoafski]

I Have a replacement ignition switch ( Stude International ) that has started to rotate almost 360 degrees in the bezel It's a hit or miss proposition...

[Flthdchamp]

Hello, I’m new to the Studebaker community. Although I’ve owned several classic cars in the past, I’ve never had anything as old as the 1950 Champion...

[yoyoman]

I am in the middle of a move and my repair manual is in the storage locker. Can anyone please give me the Timing setting and the Dwell setting and spark...