Hurst Shifter Install (Ford Pick-UP)

[345 DeSoto]

SN-60 - If I need to, I can drop it down a bunch...

[evilhawk]

I have the exact same shifter and was thinking of dropping it into my 59 Hawk. Let me know how it works out for you.

[SN-60]

Well it's a Ford Truck shifter going in his '56 Sky Hawk Jack, so I wonder if fitting it to his Floor and Seat will be a problem in that position?

I think the shifter mechanism probably will be fairly high.....Might need some type of console around it.

[StudeRich]

On a truck, where the shifter can mount high and forward, as he said, it's cake. On cars, where most want the shifter down and back, is where the confluence with the OD gets problematic.
jack vines

Well it's a Ford Truck shifter going in his '56 Sky Hawk Jack, so I wonder if fitting it to his Floor and Seat will be a problem in that position?

[SN-60]

Nice solid job!....I LOVE those Hurst floor shifters!

[345 DeSoto]

STUDERICH - It's a Hurst 501 0016, Indy Pick - Up Truck Shifter. Thanks to all the advise I got on the Forum when I asked about Shifters, this is what settled on. Bought it on ebay, slightly used, for under $100.

[PackardV8]

Looks like it fit around the O.D. Solenoid Ok, that is usually the hard part. Which one of the many Hurst or Mr. Gasket shifter Models is this one?

On a truck, where the shifter can mount high and forward, as he said, it's cake. On cars, where most want the shifter down and back, is where the confluence with the OD gets problematic.

jack vines

[StudeRich]

Looks like it fit around the O.D. Solenoid Ok, that is usually the hard part. Which one of the many Hurst or Mr. Gasket shifter Models is this one?

[345 DeSoto]

After asking about which shifter fork was which, I went out in the garage and installed my Ford pick-up shifter on my Hawk, T86. Piece of cake...minimal fabrication involved.