Announcement

Collapse

Get more Tips, Specs and Technical Data!

Did you know... this Forum is a service of the Studebaker Drivers Club? For more technical tips, specifications, history and tech data, visit the Tech Tips page at the SDC Homepage: www.studebakerdriversclub.com/tips.asp
See more
See less

63 Hawk R2 axle ID

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Rear Axle: 63 Hawk R2 axle ID

    Tag on my axle : 43-13. 3.31. So it has 3.31 ratio. Spicer 27 or 44?

  • #2
    Dana 44 and on your car more than likely a twin trac.

    Look for a second tag on the cover.

    Robert Kapteyn

    Comment


    • #3
      I see the twin traction tag and also a tag 45B.

      Comment


      • #4
        Look for a "44" cast into the housing at bottom right of the center,looking at it from rear.
        Oglesby,Il.

        Comment


        • #5
          It would be a serious Mistake if a Dana 27 destined for a 6 Cly. or a 259 ended up in an R2 289 Hawk!

          Also it would have be recently installed, because it would not last much more than a week!
          StudeRich
          Second Generation Stude Driver,
          Proud '54 Starliner Owner

          Comment


          • #6
            Rich you can be funny at times, thx.

            Comment


            • #7
              Originally posted by StudeRich View Post
              It would be a serious Mistake if a Dana 27 destined for a 6 Cly. or a 259 ended up in an R2 289 Hawk!

              Also it would have be recently installed, because it would not last much more than a week!
              Rich-
              You just provided a clue about how you drive. A 27 will last forever in a car driven by a little old lady.
              Skip Lackie

              Comment

              Working...
              X