Announcement

Collapse
No announcement yet.

swapping an LS2 into an Avanti

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Xcalibur, Click image for larger version

Name:	IMG_2391.jpg
Views:	1
Size:	122.3 KB
ID:	1700037
    Attached Files

    Comment


    • #17
      Thanks, Springstreet, for the pix. Lookin' GOOD! I'm sure you said at some point, what headers are those, please? Just curious since they look a lot like the Hookers I used, except perhaps your dumps may be farther back... can't tell for sure from the one pic. Thanks, again!

      Comment


      • #18
        Originally posted by Xcalibur View Post
        Thanks, Springstreet, for the pix. Lookin' GOOD! I'm sure you said at some point, what headers are those, please? Just curious since they look a lot like the Hookers I used, except perhaps your dumps may be farther back... can't tell for sure from the one pic. Thanks, again!
        They are Hookers (ceramic coated) with rear dumps. Some folks said they would interfere with the stock GTO starter but I have clearance. BClick image for larger version

Name:	IMG_2392.jpg
Views:	1
Size:	115.1 KB
ID:	1700059Click image for larger version

Name:	IMG_2388.jpg
Views:	1
Size:	98.7 KB
ID:	1700060Click image for larger version

Name:	IMG_2381.jpg
Views:	1
Size:	168.9 KB
ID:	1700061

        Comment


        • #19
          Yes, the same headers I use. I used the MSD starter with limited "clockability" but it was still close. Nice job, thanks.

          Comment

          Working...
          X