Announcement

Collapse
No announcement yet.

ID engine in 2R10

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Larry Garside
    replied
    Dwain, thank you very much. I did not think about the "I" for "1" issue when I read the number. Actually, the number could be the top of a mis-stamped "4"; the use of I by Studebaker actually makes it unlikely to misread a partial 4 that way. I really appreciate your efforts on forums and the Co-Operator.

    Leave a comment:


  • Dwain G.
    replied
    It's a 1951 engine that was originally in a Champion car. The aluminum tag was installed by an unknown rebuilder at some time in the past. This is basically the same engine as the original one the truck was built with. The question mark you put in the engine number I assume is because you didn't know if the figure before it was a numeral '1' or a capitol letter 'I', is that correct? It is a numeral. Studebaker stamped them that way.

    Leave a comment:


  • Larry Garside
    started a topic Engine: ID engine in 2R10

    ID engine in 2R10

    I have the following information on the engine that is in a 1952 2R10 pickup. I have just started to have some engine and drive train work done to get the truck running again. I'm new to the forum, so the information may be more than needed. Can anyone tell me what this engine is? I'm doubtful it is original; see following: .
Working...
X