Announcement

Collapse
No announcement yet.

Brake drums

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Randy_G
    replied
    Drum update, I went to my Napa today and they had a machine that could do the job. The ole guy had to compare my hubs to a VW but they are all dressed now and ready for installation this weekend! Then I get the fun task of bleeding the new system and checking for leaks.

    Randy_G
    1959 Lark Sedan
    www.AutomotiveHistoryOnline.com

    Leave a comment:


  • JDP
    replied
    They have the small shaft at my shop, keep looking.

    JDP/Maryland
    64 Daytona HT/R2 clone
    64 GT R2
    63 Lark 2 door
    52 & 53 Starliner
    51 Commander
    39 Coupe express
    39 Coupe express (rod)

    Leave a comment:


  • 38 stud
    replied
    The drums on my 1938 President were about 1 1/8". The machine had a 1 inch shaft so I was able to get them done.

    Good luck, Jim

    Leave a comment:


  • Randy_G
    started a topic Brake drums

    Brake drums

    This is just food for thought and maybe a little advice from the more advised members of this forum. Today "Sunday" I went to get the Larks drums turned by my local auto parts store and they couldn't turn the rears because the shaft diameter on the machine was too large to fit the drum.[B)] I will be trying more places tommorow, I'm hoping I find a guy with an older machine to get the job done. Good times!

    Randy_G
    1959 Lark Sedan
    www.AutomotiveHistoryOnline.com

Working...
X