Announcement

Collapse
No announcement yet.

ignition switch in hawk

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • ignition switch in hawk

    How do I get the ignition switch out of my 1961 hawk? I was toying around with the other dash I have and this spring pop out and the switch was on the floor I think I broke the retainer. It must have been half disassembled because I don't have enough parts to put it back in.

    Studebakers forever!
    Studebakers forever!

  • #2
    The ign switch has two dogs on its sides that lock into hooks on the backside of the bezel with a push and twist(not unlike tail/brake light bulbs). The big coiled spring provides the tension to keep the switch and bezel locked together.

    Note that the original bezels are potmetal which WILL eventually fatigue and break. The risk then is that the hot wires on the backside of the switch will short across any grounded metal they may come into contact with. Not Good... especially with fiberglass dash boards!

    I think Studebaler International or others sell a machined bezel that should not break. Also not a bad idea to put some electrical tape over those hot posts.

    Hope this helps.

    Comment


    • #3
      thanks skyway, the bezel broke that's why it seems that I don't hasve enough parts will call to find a replacement tomorrow!

      Studebakers forever!
      Studebakers forever!

      Comment


      • #4
        I think there should also be a nylon collar/spacer to keep it fitting tight.
        "All attempts to 'rise above the issue' are simply an excuse to avoid it profitably." --Dick Gregory

        Brad Johnson, SDC since 1975, ASC since 1990
        Pine Grove Mills, Pa.
        '33 Rockne 10,
        '51 Commander Starlight,
        '53 Commander Starlight "Désirée",
        '56 Sky Hawk

        Comment

        Working...
        X