Announcement

Collapse

Get more Tips, Specs and Technical Data!

Did you know... this Forum is a service of the Studebaker Drivers Club? For more technical tips, specifications, history and tech data, visit the Tech Tips page at the SDC Homepage: www.studebakerdriversclub.com/tips.asp
See more
See less

1937 Dictator Bulkhead connector

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 1937 Dictator Bulkhead connector

    Hey! On my usually dependable '37 Dictator The Bulk-Head Connector is in need of repair. The Connector is that "pc-board looking" assembly where the interior and exterior wiring harness is connected (on the firewall). Does anybody know where I may obtain one of these? The electrical supply dealers do not carry this. I think it was only used in 1936 & 37. Any advise or help? Thanks, Tom LaMartina, Lynchburg, VA

    Tom LaMartina

  • #2
    The rubber/plastic piece is sold by Steele rubber
    http://www.steelerubber.com/

    Did you try Bob Kapteyn at Joliet Studebaker Parts?
    He specializes in pre-war Stude's...
    Joliet Studebaker
    112 Bissell St
    Joliet, Il.
    815-722-7262

    Hope the info helps!
    Jeff[8D]



    quote:Originally posted by tlamarti

    Hey! On my usually dependable '37 Dictator The Bulk-Head Connector is in need of repair. The Connector is that "pc-board looking" assembly where the interior and exterior wiring harness is connected (on the firewall). Does anybody know where I may obtain one of these? The electrical supply dealers do not carry this. I think it was only used in 1936 & 37. Any advise or help? Thanks, Tom LaMartina, Lynchburg, VA

    Tom LaMartina


    DEEPNHOCK at Gmail.com
    Brooklet, Georgia
    '37 Coupe Express (never ending project)
    '37 Coupe Express Trailer (project)
    '61 Hawk (project)
    http://community.webshots.com/user/deepnhock

    HTIH (Hope The Info Helps)

    Jeff


    Get your facts first, and then you can distort them as much as you please. Mark Twain



    Note: SDC# 070190 (and earlier...)

    Comment


    • #3
      THANKYOU , I'VE BEEN NEEDING TO REACH BOB ABOUT R5089

      Comment

      Working...
      X