Get more Tips, Specs and Technical Data!

Did you know... this Forum is a service of the Studebaker Drivers Club? For more technical tips, specifications, history and tech data, visit the Tech Tips page at the SDC Homepage:
See more
See less

Cam plug

This topic is closed.
  • Filter
  • Time
  • Show
Clear All
new posts

  • Cam plug

    This may be a stupid question to you that do this on a regular basis but do I need to remove the freeze plug at the rear of the camshaft before I send my block to be cleaned and have new cam bearings installed? Thanks for the help,

    Darryl C. Lewallen Clarkesville, Ga.

  • #2
    I'm sure the machine shop will do that, they have to knock the old cam bearings out so the plug needs to go
    Frank van Doorn
    Omaha, Ne.
    1962 GT Hawk 289 4 speed
    1941 Champion streetrod, R-2 Powered, GM 200-4R trans.
    1952 V-8 232 Commander State "Starliner" hardtop OD