Announcement

Collapse

Get more Tips, Specs and Technical Data!

Did you know... this Forum is a service of the Studebaker Drivers Club? For more technical tips, specifications, history and tech data, visit the Tech Tips page at the SDC Homepage: www.studebakerdriversclub.com/tips.asp
See more
See less

Rear wheel squeak

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • gordr
    replied
    quote:Originally posted by mike gaines

    Hi Guys , my 58 Silverhawk has a squeak coming from the rear wheels - brake drums , I have checked that the shoes are not dragging on the drums. the squeak is related to the wheel speed and dissapears on braking ? Also have installed BMW 5 serieas power steering and the car seems to wander as speed increases. someone has suggested a power regulator to stiffen the steeering as speed increases ? could it just be wheel alignment ? Maybe a smaller steering wheel ?
    Doggone!

    I had composed a nice detailed reply, only to lose it because I was not properly logged into the site for some obscure reason.

    My .02 worth:

    check for cracked rims; look near the lug nuts and around the perimeter of the wheel mounting plane.

    check for loose axle nuts; look for red powdery rust coating the washer beneath the castle nut.

    check for bent axle; put rear axle on jackstands and run car slowly in gear and look for a wobbling rear wheel.

    check for loose hubcaps/wheelcovers; remove same and see if squeak vanishes.

    The first three can be dangerous! Please do check carefully.

    I, too would like to see pics of your BMW steering install. Is yours a RHD car?

    Gord Richmond, within Weasel range of the Alberta Badlands

    Leave a comment:


  • 55s
    replied
    Usual sources of rear squeaking are hubcaps and loose hardware inside drum (spring or clips fallen off?)

    For wandering, radil tires are much beter than bias ply - you did't mention what you were running.

    Paul R

    Leave a comment:


  • Roscomacaw
    replied
    You say: "Rear wheels - brake drums" implying that both sides are involved. Or is it that you just don't know which side it's coming from?
    I'd have someone else listen or drive while you listen from the back seat and see where it emanates from. That narrows it down a bit.
    Then I'd check to see if I could detect where the backing plate might be slightly contacting the drum. This could explain the squeak's disappearance as the brakes are applied.

    As to the wandering, while I've never had first-hand experience subbing some other brand's steering components, I do know that improper installing of rack & pinion units can cause bump steer woes on a Stude car. [B)]

    Miscreant at large.

    1957 Transtar 1/2ton
    1960 Larkvertible V8
    1958 Provincial wagon
    1953 Commander coupe
    1957 President 2-dr
    1955 President State
    1951 Champion Biz cpe
    1963 Daytona project FS

    Leave a comment:


  • sbca96
    replied
    quote:Originally posted by PackardV8
    Second, Studebaker Service Bulletins added a hydraulic steering stabilizer for late Hawks with complaints of steering shimmy or wander. This will help a bit, also. Good luck with finding a kit today.
    I have one of these, well, I have the brackets on the car, but the
    arm is long gone. I installed it on a manual steering car to help to
    solve a wander problem that I dont remember how I solved now. It came
    off a 63 GT Hawk. How did you install a BMW PS setup, and what parts
    did you add??

    Tom

    Leave a comment:


  • PackardV8
    replied
    Hi, Mike,

    Because of Studebaker's farm wagon background, they specified negative caster to make the non-PS cars easier to park. When they got a few non-farmer customers who began driving cars on paved roads at higher speeds, this lack of caster caused high-speed wander in PS cars.

    First, have you had an alignment by someone who has read the manual and knows how to do it the Stude way? Make sure they crank in all the positive caster your adjustment will allow. Some cars will barely make it to zero caster, but even that will help.

    Second, Studebaker Service Bulletins added a hydraulic steering stabilizer for late Hawks with complaints of steering shimmy or wander. This will help a bit, also. Good luck with finding a kit today.

    thnx, jv.

    PackardV8

    Leave a comment:


  • Guest's Avatar
    Guest started a topic Rear wheel squeak

    Rear wheel squeak

    Hi Guys , my 58 Silverhawk has a squeak coming from the rear wheels - brake drums , I have checked that the shoes are not dragging on the drums. the squeak is related to the wheel speed and dissapears on braking ? Also have installed BMW 5 serieas power steering and the car seems to wander as speed increases. someone has suggested a power regulator to stiffen the steeering as speed increases ? could it just be wheel alignment ? Maybe a smaller steering wheel ?
Working...
X