Announcement

Collapse

Get more Tips, Specs and Technical Data!

Did you know... this Forum is a service of the Studebaker Drivers Club? For more technical tips, specifications, history and tech data, visit the Tech Tips page at the SDC Homepage: www.studebakerdriversclub.com/tips.asp
See more
See less

50 champion brake problem.

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • ROADRACELARK
    replied
    You didn't say wheather you replaced the brake shoe return springs and the shoe hold down spring clips. If not, this can cause the brakes not to completely release. It's always a good idea to replace this hardware when doing a brake overhaul... those springs snd clips have been through MANY heat cycles and no tellin' how old they are. OBTW, a bad flexible brake hose (one at each front wheel, one at the rear axle) can cause a wheel to drag. Those old hoses deteriorate from the inside even though they may look ok on the outside. Hope this may help.
    Dan

    Leave a comment:


  • Roscomacaw
    replied
    If you take the drum off again, look to see if the edge of a shoe is contacting the sidewall of the drum.[8D] Should be easy to see if this is the case. If so, check to see that all the hardware's sitting true on the backing plate.

    Miscreant at large.

    1957 Transtar 1/2ton
    1960 Larkvertible V8
    1958 Provincial wagon
    1953 Commander coupe
    1957 President 2-dr
    1955 President State
    1951 Champion Biz cpe
    1963 Daytona project FS

    Leave a comment:


  • sbca96
    replied
    quote:Originally posted by 50starlite

    I've rotated the wheel by hand while applying light pressure to the brake pedal and can feel a difference in the drag through a 360 deg. revolution. Weak spring, adjuster out of whack?? With the drumb off everything looks fine. Also, the car stops straight.
    Sounds like your drum is out of round, and if you need to push on the
    brake to get the shoe to touch, I think your brakes are loose. I have
    heard of people going out and purposely dragging their brakes to get
    them extra hot, and then parking the car without parking brake on, to
    let them cool naturally - without pressure on the drum. Sometimes this
    can cause a warped drum (or disc) to settle back to its medium. Just
    dont get it TOO hot and cause "hot spots".[B)]

    Tom

    1963 Studebaker Avanti, 102,000, custom made brake brackets to mount 1998 Mustang GT 4 wheel disc brakes (soon to get 13" Cobra front brakes, 2003 Mustang Cobra 17" wheels, GM altenator, will be getting : 97 Camaro Z28 tan leather seats, 97 Camaro Z28 T-56 6-speed trans, Ported 'R3' style Avanti heads with stainless full flow valves, 'R3' 276 duration cam w/chrysler solid lifters, shortened push rods, aluminum cam gear, Edelbrock AFB Carb, GM HEI distributor, 8.8mm plug wires, waiting in the garage.

    Leave a comment:


  • Guest's Avatar
    Guest started a topic 50 champion brake problem.

    50 champion brake problem.

    I put all new shoes on my 50 champion about 800 miles ago. Lately the left front brake assembly has developed a draging sound when the brakes are applied at any pressure, or at least at a low speed.

    I've rotated the wheel by hand while applying light pressure to the brake pedal and can feel a difference in the drag through a 360 deg. revolution. Weak spring, adjuster out of whack?? With the drumb off everything looks fine. Also, the car stops straight.

    Dick Lee
Working...
X