Announcement

Collapse

Get more Tips, Specs and Technical Data!

Did you know... this Forum is a service of the Studebaker Drivers Club? For more technical tips, specifications, history and tech data, visit the Tech Tips page at the SDC Homepage: www.studebakerdriversclub.com/tips.asp
See more
See less

PCV valve?

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Roscomacaw
    replied
    Funny - I was ordering some ignition parts for this 54 Champion two days ago and I noticed that my OLD Echlin book showed part #s for PCV valve apps in Studebakers. I ordered two of the 29267 valves just to have on hand.
    Some of the other numbers in that book are NLA[V]

    Miscreant at large.

    1957 Transtar 1/2ton
    1960 Larkvertible V8
    1958 Provincial wagon
    1953 Commander coupe
    1957 President 2-dr
    1955 President State
    1951 Champion Biz cpe
    1963 Daytona project FS

    Leave a comment:


  • N8N
    replied
    Thanks Dan, I looked it up and it is still available and the picture looks about right.

    ddub - the "R" motor cars had the PCV valve screwed into the baseplate of the carb rather than inline. should be a piece of cake to "convert" - just get a new hose to the elbow.

    only gotcha I see is, is the check valve in the right direction? but for $5 I will find out.

    thanks!

    nate

    --
    55 Commander Starlight
    62 Daytona hardtop
    http://home.comcast.net/~njnagel

    Leave a comment:


  • ddub
    replied
    Have the same problem in a 64 Champ. Can you be a little more specific for the less knowlegeable on how to do this conversion?

    53 Commander Hardtop
    64 Champ 1/2 ton
    WA state

    Leave a comment:


  • Dan White
    replied
    That NAPA # might be listed as an Echlin # not sure how NAPA might list it, can't remember.

    Dan White
    64 R1 GT
    64 R2 GT

    Leave a comment:


  • Dan White
    replied
    I believe it is: NAPA # 29267, Myer's Studebaker has NOS ones.

    Dan White
    64 R1 GT
    64 R2 GT

    Leave a comment:


  • N8N
    replied
    I could do that, if I had a part number for that one

    nate

    --
    55 Commander Starlight
    62 Daytona hardtop
    http://home.comcast.net/~njnagel

    Leave a comment:


  • Dan White
    replied
    I assume you mean the one for the non-R series, ie. the one in the valley pan? If so why not block it off and use one for the R-series that screws into the carb. Available at Napa for about $6.

    Dan White
    64 R1 GT
    64 R2 GT

    Leave a comment:


  • Guest's Avatar
    Guest started a topic PCV valve?

    PCV valve?

    Anyone know of a good replacement for the PCV valve for a '63 V-8? Or perhaps have a good used or NOS one they'd be willing to part with? Apparently there is no modern interchange, or at least not one that any manufacturer of auto parts is willing to admit to.

    nate

    --
    55 Commander Starlight
    62 Daytona hardtop
    http://home.comcast.net/~njnagel
Working...
X