Announcement

Collapse

Get more Tips, Specs and Technical Data!

Did you know... this Forum is a service of the Studebaker Drivers Club? For more technical tips, specifications, history and tech data, visit the Tech Tips page at the SDC Homepage: www.studebakerdriversclub.com/tips.asp
See more
See less

'54 HT trunk floor

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • '54 HT trunk floor

    At age 15 I bought myself my first car, a '52 Studebaker 4-dr V-8 for $25 and taught myself to drive. Now some years later and numerous ground up street rod builds, I find myself putting all of my car experiences into my latest, lets say my version of a '54 Champion Hard Top. Purist may not apreciate the smoothing, leveling top chop or the air ride suspension, but Studebaker nuts will like the "built" flathead six with the T-5 5-speed tranny, dual carb and tuned header.
    The frame and drive train is all finished and powder coated. Most of the body work is finished and the body is on a rotisserie. The car can be seen at www.theroto2000.com. The floor is finished with the exception of the trunk rear floor pan dimples (their must be a better name for them). The circiular sheet metal that extends down to the frame and surrounds the rear bolt holes. You can buy the trunk corners, but mine is all finished and I hate to buy them just to cut out the 3 1/2" piece. So I thought I would ask on this forum first to see if anyone out there could help me out. Thanks for listening, I am looking forward to reading what other studebaker people are doing. Dave in Spokane

  • #2
    Hard to tell much from those pictures. I have no comments since I can't see much detail.
    [8D]

    Miscreant at large.

    1957 Transtar 1/2ton
    1960 Larkvertible V8
    1958 Provincial wagon
    1953 Commander coupe
    1957 President 2-dr
    1955 President State
    1951 Champion Biz cpe
    1963 Daytona project FS
    No deceptive flags to prove I'm patriotic - no biblical BS to impress - just ME and Studebakers - as it should be.

    Comment


    • #3
      Sounds like you want the trunk floor corner supports as listed here:
      http://www.classicent.com/index.htm

      Dwain G.

      Comment

      Working...
      X