Announcement

Collapse

Get more Tips, Specs and Technical Data!

Did you know... this Forum is a service of the Studebaker Drivers Club? For more technical tips, specifications, history and tech data, visit the Tech Tips page at the SDC Homepage: www.studebakerdriversclub.com/tips.asp
See more
See less

Placement of 64 Hawk R2 Fender emblems

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • studebaker-R2-4-me
    replied
    Thanks Dan and Barry,

    Barry, I really was not thinking when I posted this topic. I should have just made a phone call and asked you!

    When I searched the topic in the forum, nothing came up. The information will be useful to the next guy building a R1 or R2 clone

    Allen

    1964 GT Hawk soon to be R2 Clone

    Leave a comment:


  • studee64
    replied
    Allen

    this one might be more clear...



    Barry Leppan
    Burlington, Ont. Canada
    64 Daytona HT 5-spd
    64 GT Hawk R-1/AC/Powershift

    Leave a comment:


  • studee64
    replied
    Allen

    Found a pic for you to see...


    [img]http:i86.photobucket.com/albums/k107/studee64/DSCP5347.jpg[/img]
    Barry

    Barry Leppan
    Burlington, Ont. Canada
    64 Daytona HT 5-spd
    64 GT Hawk R-1/AC/Powershift

    Leave a comment:


  • studee64
    replied
    Allen

    Come over and look at my R-1 64 GT...I believe the emblems are in the same place for both R-1 & R-2..

    Barry

    Barry Leppan
    Burlington, Ont. Canada
    64 Daytona HT 5-spd
    64 GT Hawk R-1/AC/Powershift

    Leave a comment:


  • ivorydan
    replied
    Allen, when I bought my 64 R1 Hawk in 1973, It still had one of its emblems(driver's side). The other side had a big hole in the fender instead of the badge.

    The badges were centered directly below the vent openings. The top center of the emblem retainer ring is .75 inches below the bottom of the indent for the vent seal.

    Leave a comment:


  • studebaker-R2-4-me
    started a topic Placement of 64 Hawk R2 Fender emblems

    Placement of 64 Hawk R2 Fender emblems

    I am looking for measurements to accurately place the fender emblems on my hawk. I will have to drill two holes into the fender. My intention will be to place masking tape on the fender and mark cross hairs on the tape, then drill the two 1/8" holes. If someone has a picture to post of a factory R2 fender it would be really helpful.

    Allen

    1964 GT Hawk soon to be R2 Clone
Working...
X