Howdy All, I am at a point in my project that I have pulled the front axle and springs from my 4E-7 for sandblasting and painting. My question is... I have a set of NOS heavy duty springs for a 2R #678854 and #678855 in my collection of parts. Both the 4E-7 and the heavy duty 2R's springs are 9 leaf, same bushing curl directions, length, etc. Other than the spring clips being different, does anyone know if the load capacity (spring tension) of the heavy duty 2R set would be close to that of the 4E-7's. I would rather change to the NOS set than to spend the time of tearing down and sandblasting the originals (have done this before on the original set years ago ) Or am I destined for a long sandblasting and paint job. Thanks for any information. Tim
<div align="left">Tim Stevens Big Sky Country, Montana "Mergatroid" '59 4E7-122 "Sliver" '59 Silver Hawk "Surfin Stude Safari" '57 Parkview Wagon "Blind Date" '41 Double Dater Coupe</div id="left">
<div align="left">Tim Stevens Big Sky Country, Montana "Mergatroid" '59 4E7-122 "Sliver" '59 Silver Hawk "Surfin Stude Safari" '57 Parkview Wagon "Blind Date" '41 Double Dater Coupe</div id="left">
Comment