Get more Tips, Specs and Technical Data!

Did you know... this Forum is a service of the Studebaker Drivers Club? For more technical tips, specifications, history and tech data, visit the Tech Tips page at the SDC Homepage:
See more
See less

lopsided motor

This topic is closed.
  • Filter
  • Time
  • Show
Clear All
new posts

  • lopsided motor

    my 51 champ motor is leaning to one side and the back of the motor is kicked around to one side but everything is bolted up like it suppose to be no stress on anything when un bolted.can anyone tell me anything about this. thanks

  • #2
    I would first look at the motor mounts the old rubber mounts go flat. The rear mount realy pivots about 1 point so there would be no bind. the best thing for you to do is get us some pictures.


    • #3
      It IS offset to the right about one inch.[:I] The holes in the crossmember are drilled off center.

      Miscreant at large.
      No deceptive flags to prove I'm patriotic - no biblical BS to impress - just ME and Studebakers - as it should be.