Announcement

Collapse

Get more Tips, Specs and Technical Data!

Did you know... this Forum is a service of the Studebaker Drivers Club? For more technical tips, specifications, history and tech data, visit the Tech Tips page at the SDC Homepage: www.studebakerdriversclub.com/tips.asp
See more
See less

T-5 swap clutch linkage position

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • T-5 swap clutch linkage position

    On my Stude. V-8 5-speed swap. I've bushed the Stude. release bearing according to all the info I've been able to find, so it now fits the T-5 trans. The two clutch release bearing levers on the Stude. truck bellhousing that I'm using don't point straight up as I'm assuming they should. How verticle should they be using a Stude. bellhousing,release bearing and clutch assembly? I'm asking so I can determine if I need to notch the front bearing retainer. Dclewallen

    Darryl C. Lewallen

  • #2
    It has been years since I have installed a manual transmission but if I recall correctly the fork will move or slide the clutch release bearing on the input shaft support tube and the fork itself will make a slight arch It starts pretty close to vertical and moves forward a few degrees until it meets the clutch release forks. How far forward and how far back it starts depemds on the external linkage adjustment I think. Make sure you put some grease on the inside of the bearing so it will slide smoothly and not bind up on the input flange support tube. When the fork is correct it will have enough travel to disengage the clutch from the flywheel and return just enough to not turn continuously by contact with the clutch release forks. It should feel smooth with no bind or hard spots. Hope this helps.

    Start and Stage Your Studebakers
    Start and Stage Your Studebakers

    Comment

    Working...
    X