Announcement

Collapse
No announcement yet.

51 Commander Rewire

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Roscomacaw
    replied
    There's really nothing peculiar to Stude wiring. The only thing I'd say is to snake the new harness in alongside the old one (behind the dash) and pull one connector off at a time and then replace it with the corresponding connector from the new harness. As far as where it goes through the firewall, cut the old harness there so you can feed the new one into the engine compartment. That way you can pull and replace connectors in the same fashion in the engine bay like you did under the dash.

    Miscreant at large.

    Leave a comment:


  • Commander51
    Guest started a topic 51 Commander Rewire

    51 Commander Rewire

    I'm about to begin rewiring my new-to-me Commander, and while I've rewired other old vehicles, I'm curious to learn any "do's and don'ts" any other SDC members may have for me regarding Studebakers. I"ve enlarged and colored my wiring schematic, have my harnesses in hand from Studebakers West, and purchased a 6 volt alternator-- but I'm sure there are a few 'tricks' I need to be aware of...

    Many thanks!!!
Working...
X