Decal Placement

[birdbrain1]

Hate to clutter up the forum, but I might as well ask for the sake of authenticity.

My 55 Speedster has of course the script "Speedster",close to the door opening of the rear stainless trim.

Close to the script toward the door is a round decal with an arrow on half of it and a checker board on the other half.

The replacement for this decal has four posts to be inserted into the holes in the trim. However, I have only two holes so no matter which holes I use, the arrow and checker board always come out at one angle or another.

I removed the posts and put two sided tape on the back. Here are the questions:

1 Should the bottom of the decal line up with the bottom of the script or should it be centered on the script?

2. Should the arrow half be at the top and the checkered part on the bottom or vice versa?

Henry

[klifton1]

First it should be an metal ornament not a decal. Part number 311426vwp right and 311427vwp left. They are about centered on the stainless. The red part to the front, arrow at an angle.
Klif

55 Speedster
63 Avanti R2
63 Lark R2

[Roscomacaw]

Harry, here's a company Speedster postcard. Shows the orientation AND location with respect to the script.

http://www.flickr.com/photos/autohistorian/3960763278/

1957 Transtar 1/2ton
1963 Cruiser
1960 Larkvertible V8
1958 Provincial wagon
1953 Commander coupe
1957 President two door