I just replaced the rubber on the rear windows, but had to drill out the orignal steel rivets, should I just use the alumminum pop rivets that I just fit in the holes ,or is there something stronger out there? 55 president c body (Airplane ????)
-
-
Use stainless or steel. Don't use aluminum as corrosion will occur at the alum steel body interface. -
Go to McMaster-Carr website and you can find any type of rivet you want.
David LDavid LComment
-
-
SI sells the correct chrome top rivets but the price is $1 each.[:0]"All attempts to 'rise above the issue' are simply an excuse to avoid it profitably." --Dick Gregory
Brad Johnson, SDC since 1975, ASC since 1990
Pine Grove Mills, Pa.
'33 Rockne 10,
'51 Commander Starlight,
'53 Commander Starlight "Désirée",
'56 Sky HawkComment
-
For most common pop rivets go to Ace Hardware, that's where I get my steel and Aluminum. For the others, Mcmaster-Carr.
Bob
Comment
-
I've tried McMaster-Carr and Grainger; just can't find the correct chrome tops."All attempts to 'rise above the issue' are simply an excuse to avoid it profitably." --Dick Gregory
Brad Johnson, SDC since 1975, ASC since 1990
Pine Grove Mills, Pa.
'33 Rockne 10,
'51 Commander Starlight,
'53 Commander Starlight "Désirée",
'56 Sky HawkComment
-
you might try byler rivots i buy from them and they are located in tx
apComment
Comment