rocker panel inner and outer install.

[NormK]

Thank you soooo much they clear up everything.

[1953champcoupe]

Here are pictures, note.....I did not weld the lower portion of the rear to the removable quarter panel, I don't know if the factory did or not.....this is on a 53 and there were no inner rockers on mine at all. Not great pictures

[1953champcoupe]

After you get the rockers installed it will be fairly evident how they fit. Sorry I don't have any pictures..the lower part of the inner rocker will plug weld to the inner and if I remember correctly I then plug welded the upper portion to the floor. If you don't get a "good" answer after you get the rockers installed send me a PM and I will take pictures. I suspect someone else will have pictures of that. the "kick up" in the inner matches with the kick up in the floor..ain't this fun

[NormK]

I am getting ready to install the rocker panels on my 56 Power Hawk. Would anyone here happen to have a picture or diagram of how the inner panels go in? The diagram on the Classic enterprise's page can't be blown up to get a good look at, or it could just be me.(operator error)! Any help would be greatly appreciated.