Announcement

Collapse
No announcement yet.

Engine lift

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • altair
    replied
    Scrub the above with head on it won't matter

    Leave a comment:


  • altair
    replied
    Rather than use your head bolts use some shorter ones 1 1/2 - 2 inch

    Leave a comment:


  • Jwboff
    replied
    Thanks, It’s going in together engine bell and tranny. I have a leveler on my hoist. Always like to check with you guys. Always learn something.

    Leave a comment:


  • StudeRich
    replied
    The "Balance Point" will depend on if you do the most common combination of: Engine, Bell Housing and Transmission or something else.

    You basically have little choice, but to just use a Left and a Right Side, Front and Rear Head Bolt that balances the Combo or Non-Combo. The farther you screw the Bolts in, the less chance of bending them.

    Leave a comment:


  • Jwboff
    started a topic Other: Engine lift

    Engine lift

    Looking to finally put in my rebuilt flat six into my Champ. Just wanted to check with you guys as to the best pick up points. Can I use the head bolts? And if so any ones in particular? Center/outside?
Working...
X