Announcement

Collapse
No announcement yet.

61 Hawk Wiper Motor

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Cus63
    replied
    On closer inspection, & I also ran the motor, it does miss the wall, but not by much,
    I guess that's all it has to do, I have the original motor from my '61 & one from a '62 GT,
    the rubbers look the same,

    regards, Cus

    Leave a comment:


  • StudeRich
    replied
    So the Wiper Arm Drivers and Center "Wheel" fit too tight to the Inside of the Firewall?

    Wrong Insulators and spacers in the 3 Mounting Bracket Holes?
    Last edited by StudeRich; 01-02-2020, 05:01 PM.

    Leave a comment:


  • Cus63
    started a topic Other: 61 Hawk Wiper Motor

    61 Hawk Wiper Motor

    Fitted up the Wiper motor yesterday,
    noticed that the mounting stud & plate for the arms doesn't sit very proud of the firewall,
    I would say , almost touching, even done up fairly tightly,
    not sure if that's the norm,

    regards, Cus
Working...
X