Announcement

Collapse

Get more Tips, Specs and Technical Data!

Did you know... this Forum is a service of the Studebaker Drivers Club? For more technical tips, specifications, history and tech data, visit the Tech Tips page at the SDC Homepage: www.studebakerdriversclub.com/tips.asp
See more
See less

Swapping P/S from Hawk to Lark

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • abkco
    replied
    I just took out power steering from a 63 Hawk and put it in my 63 Lark. Like others above have said, you need a Lark Pitman and Reach Rod. Hoses are different for the years you are talking about. If you aren't sure about the quality of your used parts, you might want to rebuild the pump, control valve and ram.

    Leave a comment:


  • StudeRich
    replied
    The BEST Tool you need in your Toolbox is the '59-'64 Chassis Parts Catalog, you compare all the Parts to learn what you will need to buy to make the conversion.

    The only good news is, you should be good with the existing Steering Gear and Column in your '64 Commander.

    The bad news is, about all you can salvage from the Hawk that will fit is; the Ram, P/S Pump, Brackets, special Bolts and Crank Pulley.

    Since the Commander has a Saginaw Steering Gear and the Hawk a Ross, I don't believe the Pitman would fit if it were the right length, but I doubt it. The Catalog will tell you if I have missed anything.

    Leave a comment:


  • Roger L.
    replied
    The Pittman arm is permanently attached to the control valve. All the parts should work but it's possible that the oil lines may be different lengths. the ram mount to the frame may be different too. The nice thing about the Bendix linkage power steering is that it will work with the standard steering gear as long as the Pittman spline matches the sector shaft. The link from the control valve to the bell crank is adjustable to some degree, it could be a problem if it can't be adjusted enough. Just measure the old one and adjust the distance from the front tie rod end to the ball end of the pitman arm to be equal. The instructions are in the service manual.

    Roger List

    Leave a comment:


  • rockne10
    replied
    As well, pretty much the entire steering column; different length, shifter linkages, etc.
    You would probably be better off finding a donor Commander and selling the Hawk assemblies.
    I've only done it once, and that was from a '54 F body to a '53 C body; but that was my experience.

    Leave a comment:


  • SScopelli
    replied
    I believe the Pittman arm is also different.

    Leave a comment:


  • kevin1944
    started a topic Steering: Swapping P/S from Hawk to Lark

    Swapping P/S from Hawk to Lark

    I want to take P/S from a 63 GT I'm parting out & put it on a 64 Commander,what do I need to do & look out for ? EG the reach rod for Commander appears to be shorter
    Anything else to be aware of ?
Working...
X