Announcement

Collapse
No announcement yet.

Door check pins

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • leyrret
    replied
    I too use a 1/4" bolt. I don't use a nut. Yet to have one come out.

    Leave a comment:


  • rockne10
    replied
    It doesn't take much peening to keep it from backing out. I use a body dolly underneath and a hammer on top; a couple of confident taps and your done. Without a dolly, another hammer would suffice.

    Leave a comment:


  • 52 Ragtop
    replied
    I use a stainless steel 1/4" x 1/2" button head allen and a nylock, works and looks just fine. Tighten up the nylock until just snug. Using a nylock nut it will not back off.

    Jim

    Leave a comment:


  • JDP
    replied
    Yes, peaned out.

    JDP/Maryland

    Leave a comment:


  • terrymb
    started a topic Door check pins

    Door check pins

    Just got a set of door check pins from SI to replace the screws being used before. Is the bottom of the pin supposed to be flared out or something? Or does the pin just sit there. Seems like it could bounce out when there is no tension on it.
    Thanks for the info.
    Terry

    1952 Commander Starlight
    Green Lake, WI
Working...
X