Announcement

Collapse

Get more Tips, Specs and Technical Data!

Did you know... this Forum is a service of the Studebaker Drivers Club? For more technical tips, specifications, history and tech data, visit the Tech Tips page at the SDC Homepage: www.studebakerdriversclub.com/tips.asp
See more
See less

A Bad Studebaker Night

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Blue 15G
    replied
    Things went better tonight. Pulled the right rear drum, and it took the normal amount of difficulty to remove it (a good sign). The drum is fine and so are the shoes and cylinder. I do have to replace my inner grease seals, though, on both sides. Guess while I'm at it I'll check the axle end play. Things don't seem as bad now. The only thing that hurts is having to buy a new drum due to my own mistake. [xx(]

    Leave a comment:


  • Blue 15G
    replied
    Thank you for your support. Yes, I know things could have been a lot worse, so I am grateful.

    Leave a comment:


  • Swifster
    replied
    A bad day with your Studebaker is better than a good day at work (as long as no one gets hurt).

    ---------------------------------------------------------------------------------------------------
    Tom - Lakeland, FL

    1964 Studebaker Daytona

    Michigan Speed - www.michiganspeed.com
    Club Hot Rod - www.clubhotrod.com
    LS1 Tech - www.ls1tech.com

    Leave a comment:


  • Dick Steinkamp
    replied
    Sounds like more good news than bad news to me. You caught it in time (no wheel/tire into the rear quarter panel)...AND the brakes looked good.

    Leave a comment:


  • Blue 15G
    started a topic A Bad Studebaker Night

    A Bad Studebaker Night

    I decided to check the rear brakes on the '54 because it has been a long time since I had looked at them, and I was also hearing a small "ticking" sound while backing up.

    I got the car up on the stands and carefully installed my drum puller. Then, when I screwed the center threaded piece and centered it on the axle shaft, the drum started to come off with ONLY HAND PRESSURE! [:0] I knew I was in big trouble at that point.

    The keyway in the drum is slightly raised on one of its edges and I can see a hairline crack in it. I can't tell how the key was in because the keyway on the axle happened to be positioned at the bottom of the axle when the drum came off, so it simply fell out.

    I am mad [V] because I have no one to blame but myself for this. I have worked on these types of drums more than a few times in the last 30 years, and I was the last person in there. So all I can figure is that I accidently put the key in the wrong way last time.

    I guess it could have been worse...it could have come apart while driving. The scary thing is that other than the small ticking sound at a crawling speed, the car gave no sign of any other problem.

    The only good news is that the brake linings and wheel cylinder are both in good shape. Big whoop!

    Tonight I will pull the right side drum off. I'm afraid to look!
Working...
X