I looked at the procedure in the manual, there has to be a better way.
install a gauge to a 1/8 npt port, put trans in drive, run engine at 1000rpm and adjust the tv rod so you have a 80 to 85 psi reading. How is one person supposed to accomplish that task?
second, checking fluid level. If i follow the instructions,and add fluid the next time I put it in drive it pukes up fluid out the fill tube.
I should have went with a 700r4!!!
install a gauge to a 1/8 npt port, put trans in drive, run engine at 1000rpm and adjust the tv rod so you have a 80 to 85 psi reading. How is one person supposed to accomplish that task?
second, checking fluid level. If i follow the instructions,and add fluid the next time I put it in drive it pukes up fluid out the fill tube.
I should have went with a 700r4!!!
Comment