Announcement

Collapse
No announcement yet.

Anyone know a vendor "64hawkgt", in San Jose?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 64Avanti
    replied
    I run 1.88 bearing on my Bonneville engine. Have only run to 8,000 RPM. I wouldn't worry too much about being .040 under.

    Leave a comment:


  • PackardV8
    replied
    Originally posted by (S) View Post
    Wow, .040 oversize. Is it just that everybody wants less turned off of the crank, or in your experience does this work for long life or high revs? Fill me in please.
    All Studebaker V8s have forged crankshafts and NASCAR engines turn 9,000 RPMs with a 3.25" stroke crank and 1.888" rod bearings. This would be .112" undersize on a 259" crank, so maybe no worries at .040"?

    jack vines

    Leave a comment:


  • StudeRich
    replied
    I show that only Champion 169/170 Engines have .040 and .060 undersize Rod Bearings available.
    THAT sounds even more scary than on Larger V8 Rods!

    Leave a comment:


  • (S)
    replied
    Wow, .040 oversize. Is it just that everybody wants less turned off of the crank, or in your experience does this work for long life or high revs? Fill me in please.

    Leave a comment:


  • PackardV8
    started a topic Engine: Anyone know a vendor "64hawkgt", in San Jose?

    Anyone know a vendor "64hawkgt", in San Jose?

    He runs ads on picclick and ebay. I sent an e-mail inquiry about his .040" V8 rod bearings, but never received a reply.

    jack vines
Working...
X