Announcement

Collapse

Get more Tips, Specs and Technical Data!

Did you know... this Forum is a service of the Studebaker Drivers Club? For more technical tips, specifications, history and tech data, visit the Tech Tips page at the SDC Homepage: www.studebakerdriversclub.com/tips.asp
See more
See less

Drive shaft center bearing spline shaft seal

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Drive Shaft: Drive shaft center bearing spline shaft seal

    Shop manual calls for a cork grease washer. Any one using neoprene or some other than cork?

  • #2
    There are teeth in the washer and would be hard to make.

    Comment


    • #3
      Use paper gasket material. Lay a piece over the washer and pres hard, you may get a good enough imprint to cut a pattern. The thin stuff may work better, and you may need 2.

      Comment


      • #4
        This is a 55 Commander, the pt no is 522053 and SI says no stock. So need to come up with something.

        Comment


        • #5
          I used an o-ring as described in this thread: http://forum.studebakerdriversclub.c...ht=spline+seal
          Seems to work fine.
          3H-C5 "The Blue Goose"

          Comment

          Working...
          X