'53 champion chrome removal HELP!

[rockne10]

The seals for the cowl are available but, as Jerry indicated, Dumdum may actually be a better seal.

[wolfie]

Thanks to all!! I am prepared for the body shop now!I will probably have more questions when he actually starts body dissasembly(Supposedly tommorrow(again).

[tbredehoft]

Its a 3/8, use a nut driver. When you replace the belt molding, make certain that there are fairly heavy rubber washers on the outside of the car, sealing the hole. Else you will find rain on your right ankle. I guess Jerry covered that.

[img=left]http://www.alink.com/personal/tbredehoft/Bothcars3.jpg[/img=left]
Tom Bredehoft
'53 Commander Coupe
'55 President State Sedan (Under Construction)
'60 Lark VI (Sold, delivery in early Jan.)
'05 Legacy Ltd Wagon
All Indiana built cars

[Jerry Forrester]

quote:Originally posted by wolfie

Hi, we are beginning preparations for paint and rechrome on this car and can not figure out how to remove the belt line moulding from below the windshield. I know abot the screw at the door , but do not know how else nor wher it is attached. I have a great desire to do this car right, so any info would be greatly appreciated.
Thanks, Wolfie

On the early C-K's the outer cowl molds have a screw (like you said) on the end and a stude going through the cowl next to the wiper transmission. But I don't remember if it takes a 3/8" or an 11/32" wrench. The center mold has 4 of these studs. You will need to be able to move the wiper arms in order to access all the nuts. (wipers in the parked position to get to the nuts holding the center piece on and the wipers in the out position to get to the ones on the short pieces.
When you put them back on, get some later model fasteners. With them you don't have to get up under the dash. You just pop the little springy like well nuts into the holes and push the studs down into them. Also using the later method the molding nuts don't get over tightened and deform the molding like so many of them are.
And remember, use a fair anount of DumDum (strip calk) or your floor board will get wet everytime it rains.

Jerry Forrester
Douglasville, Georgia
Be sure to check out my eBay store
http://stores.ebay.com/CHROME-CHROME-CHROME_
for your shiny Stude stuff

More pix of Leo the '55 Pres HT here...http://tinyurl.com/2gj6cu

[wolfie]

Hi, we are beginning preparations for paint and rechrome on this car and can not figure out how to remove the belt line moulding from below the windshield. I know abot the screw at the door , but do not know how else nor wher it is attached. I have a great desire to do this car right, so any info would be greatly appreciated.
Thanks, Wolfie