Announcement

Collapse
No announcement yet.

Fender Slash Apron

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • tbredehoft
    replied
    That might be .035 (inches) 35mm is 1 3/8 inches.

    Good idea, non-purists use liquid nails.

    [img=left]http://www.alink.com/personal/tbredehoft/Bothcars3.jpg[/img=left]
    Tom Bredehoft
    '53 Commander Coupe
    '55 President State Sedan (Under Construction)95 hrs.
    '60 Lark VI (Sold, delivery in early Jan.)
    '05 Legacy Ltd Wagon
    All Indiana built cars

    Leave a comment:


  • jbwhttail
    replied
    You can see below how we mounted ours on a 1956J, we used SI parts as you have. We cut and bent welding wire as our "original" staples, I believe they are 35mm diameter.

    Hope it helps.......



    It is an addiction!

    Leave a comment:


  • CKOT
    replied
    Ok, photos didn't come through, so thankfully I saved them.......






    Leave a comment:


  • CKOT
    replied
    here is the original thread
    http://www.studebakerdriversclub.com...&SearchTerms=e


    Leave a comment:


  • rockne10
    replied
    I believe this was addressed in a topic a couple years ago. I can't remember the title and can't find it in "Search"; probably been archived.

    Leave a comment:


  • 52 Ragtop
    replied
    I replaced the ones on my "former" 62 ragtop. I used some 10-24 button head allen machine screws. about 6 or 8 on each side. Not factory, but worked finr and looks fine.

    Jim

    Leave a comment:


  • John Ratliff
    started a topic Fender Slash Apron

    Fender Slash Apron

    Well, I have the under hood all painted and am ready to install the new slash aprons. I got these from S.I. and they are not like the ones that were on the car. Part # 1331759. These are very thin and seem to just flop around. The old ones were stapled to the fender.
    I can not figure out how these fit where the old ones were.
    Have any of you replaced these?
    Here is a picture of the old ones.



    John Ratliff
Working...
X