Announcement

Collapse
No announcement yet.

glass thickness '39 commander

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • fh4ever
    replied
    thanks for the reply Kurtruk. After talking with them some more...they did come back and offer the "non standard" at .218 thick since I had thickness concerns. The 1/4" was tempered but not sure what the .218 was. Now as far as the setting tape is concerned, I suppose I will have to buy some and test the fit of the vent window, door window bottom channel, and the felt channel using the original glass. Who would have the different thicknesses? I suppose SI only sells one thickness?

    Leave a comment:


  • kurtruk
    replied
    Modern laminated auto glass is normally 7/32" which is .21875 ( Likely what yours in your car is). Although if Chinese supplied there are some variances. Are they supplying laminated or tempered glass? Glass setting tape is sold in thicknesses of 1/64" increments, so not too hard to make up differences. A little tougher when putting in a gasket, though.

    Leave a comment:


  • fh4ever
    replied
    Vintage Glass

    Leave a comment:


  • kurtruk
    replied
    Who is VG?

    Leave a comment:


  • fh4ever
    started a topic Body / Glass: glass thickness '39 commander

    glass thickness '39 commander

    hi folks, I was about to order the glass kit for the '39 commander, but now I am confused on the thickness. VG says they supply it in 1/4" thick.
    The problem is all the side glass....mine measures .210". Would 1/4" be too thick for :
    both front and rear vent window frames, the door window mounting channel at the bottom of the glass?? and even the "U" channel in the door frames? I will be using new glass setting tape and I wonder is it all will be too tight to fit?

    The windshield measures .265" which I think 1/4" would work fine there. I have not removed the back glass yet but I imagine 1/4" would work fine there.

    So what thickness are other early commander restorations using ?
Working...
X