trying to find a seat for my 3r6,seems to be different, just bought a scottsman but it has the brackets on the back of the cab my 54 does not,so not sure what to do,
-
-
Your 3R6 probably came with the adjustable seat that allowed a small amount of fore-and-aft movement by pulling up on lever on the side of the seat. The Scotsman trucks used the cheaper arrangement with a hole-and-pin arrangement. I have an extra seat frame and cushions, but shipping would be prohibitive. You should be able to find one a lot closer. Suggest you post a want-to-buy ad over on Stude Truck Talk. There are several people who post there that specialize in used Stude truck parts.
http://www.network54.com/Forum/23885Skip Lackie -
thank you skip , I did end up with what looks like someone put a slider frame in the scottsman with the pin type back cushion and bottom,can you tell me what I have, the ser. # E1-766 Mod. #3E1-12. it has been wrecked there is 54 front clip on it and the frame in front has a couple inches cut off, any info. would be helpful it only shows 58k on the speed-o ,6 cyl. 3 speed o.d. thanks DinoComment
-
Can't tell you much more than you already know. 3E1-12 is a 1958 Scotsman with 170 cu in Champion 6 and 112" wheelbase. The front fenders and hood are interchangeable back to 1949 models. I don't think that OD trans will fit the Commander engine in your 3R6.Originally posted by jetboat View PostSkip LackieComment
-
my 3R6 has a new 259 out of a 60 lark, the Scotsman has no title it was a abandon auction out of Cal. very little rust,Thank you again
Comment
Comment