Announcement

Collapse
No announcement yet.

Rear axle width 1/2 ton truck

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Rocket3pilot
    replied
    lancaster pa craigslist says rear end is 390(389)

    Leave a comment:


  • StudeRich
    replied
    You do know the Truck is probably a 4.27 or 4.56 Ratio depending on the Trans. Type, an Automatic may be as high geared as only 3.73, any of these would be a bit Low Geared for a Car without Overdrive.

    If your Axle spline count is the same, the Complete Carrier should swap over however.

    Leave a comment:


  • Rocket3pilot
    replied
    Can i just swap the gears?

    Leave a comment:


  • Warren Webb
    replied
    The truck axle is wider. The width of the car housing is 52.5" vs. the truck housing is 58.25"

    Leave a comment:


  • 63t-cab
    replied
    I come up with about 58 3/4" from flange surface that mates backing plate to the other side.cars aren't as wide,but I don't have one to measure.if it's ratios you want to change you may do so with the truck housing.

    Leave a comment:


  • Rocket3pilot
    started a topic Rear axle width 1/2 ton truck

    Rear axle width 1/2 ton truck

    Does anyone know what width the rear axle is on a 58 pickup 1/2 ton. Not sure what model, thats all the info i have. Is it the same measurement as a 57 golden hawk rear axle?
Working...
X