Does anyone know what width the rear axle is on a 58 pickup 1/2 ton. Not sure what model, thats all the info i have. Is it the same measurement as a 57 golden hawk rear axle?
Announcement
Collapse
No announcement yet.
Rear axle width 1/2 ton truck
Collapse
X
-
I come up with about 58 3/4" from flange surface that mates backing plate to the other side.cars aren't as wide,but I don't have one to measure.if it's ratios you want to change you may do so with the truck housing.Joseph R. Zeiger
-
The truck axle is wider. The width of the car housing is 52.5" vs. the truck housing is 58.25"59 Lark wagon, now V-8, H.D. auto!
60 Lark convertible V-8 auto
61 Champ 1/2 ton 4 speed
62 Champ 3/4 ton 5 speed o/drive
62 Champ 3/4 ton auto
62 Daytona convertible V-8 4 speed & 62 Cruiser, auto.
63 G.T. Hawk R-2,4 speed
63 Avanti (2) R-1 auto
64 Zip Van
66 Daytona Sport Sedan(327)V-8 4 speed
66 Cruiser V-8 auto
Comment
-
You do know the Truck is probably a 4.27 or 4.56 Ratio depending on the Trans. Type, an Automatic may be as high geared as only 3.73, any of these would be a bit Low Geared for a Car without Overdrive.
If your Axle spline count is the same, the Complete Carrier should swap over however.StudeRich
Second Generation Stude Driver,
Proud '54 Starliner Owner
Comment
Comment