I am reassembling a T86 overdrive transmission that came out of a '47 Commander. The '47 & early '48 overdrive units had a somewhat different rear overdrive shaft bearing arrangement - they utilized two rear shaft bearings instead of just one in later transmissions.
To make a long story short, to ensure I am assembling this correctly I need the Overdrive 'Reassembly' pages from a '47 or '48 Shop Manual.
Anyone have a '47 or '48 car shop manual that can scan these pages for me?
Paul
Winston-Salem, NC
Visit The NEW Studebaker Skytop Registry website at: www.studebakerskytop.com
To make a long story short, to ensure I am assembling this correctly I need the Overdrive 'Reassembly' pages from a '47 or '48 Shop Manual.
Anyone have a '47 or '48 car shop manual that can scan these pages for me?
Paul
Winston-Salem, NC
Visit The NEW Studebaker Skytop Registry website at: www.studebakerskytop.com
Comment