BeforeI start assembly of the Weber motor I am reverse engineering the adapter platesfor the Weber manifold, with Jeff Rice’s approval of course. Once themotor is assembled they would be lost as no drawings were made. Not a criticism, justfact. The plates Jeff made are spot on dimension wise. You can see them on Racing Studebakers. I want to verify the intake angle to the head face of the block by a method other than measuring a head. I get 65.5 degrees head face to intake face. Can anyone verify this with their own measurements or an engineering drawing? I have the GM side data from a drawing and can measure the angle easily with it being a closed valley motor intake.
JK
JK
Comment