Studebaker Headers Rare???

[mtnmanbf]

Saw these in case someone looking! not mine! http://www.jalopyjournal.com/forum/t...years.1034367/

[Mike Van Veghten]

Interesting, but also very strange with the center tube starting small, THEN going larger.
On one hand unnecessary, on the other hand, backward.

Since there's a piston firing between each of the two pairs, there's no requirement for a large center tube, except for the width of the port.

Mike

[StudeRich]

Yes but, what about the "Collector" Feature of that Larger Center Pipe having to collect ALL Three Ports into One without restricting that larger flow?

It would be interesting to see if the Round Center Tube is at least the Full size of that Large Rectangular Center Port.
There is no Mounting face view, yet.

They should Flow about as good or better than the Factory Cast Iron Headers that people say can add from 0 to 3 H.P. and a Very Cool look.

[allstateguy]

Phone number on ad is no good

[SN-60]

Chances are they only fit the 'small port' '51-'54 232CI heads!

[clonelark]

I have an old kit, flange plates and tubes to start a header. haven't used it yet, i don't have a welder anymore . (Stolen)

[bezhawk]

Headers by Ed, used to sell kits to make your own. I wonder if they still do?

[spokejr]

Ed is still around;

http://www.headersbyed.com/