Announcement

Collapse
No announcement yet.

Reproduced Hawk Rear Quarters???

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Reproduced Hawk Rear Quarters???

    I saw this on Ebay and it sounds like a great deal for the money. I had not heard these were being reproduced. Maybe he can to the front fenders next! One can only hope.



    You probably will have to copy and paste the above

    But under $300 for a pair of rear fenders seems like he would sell a bunch
    Milt

    1947 Champion (owned since 1967)
    1961 Hawk 4-speed
    1967 Avanti
    1961 Lark 2 door
    1988 Avanti Convertible

    Member of SDC since 1973

  • #2
    I think this is only patch panels, and not the whole quarter.

    Comment


    • #3
      I just asked the seller if these are bolt on replacements. I will post when I get a response
      Milt

      1947 Champion (owned since 1967)
      1961 Hawk 4-speed
      1967 Avanti
      1961 Lark 2 door
      1988 Avanti Convertible

      Member of SDC since 1973

      Comment


      • #4
        the ad states repair panels.
        Candbstudebakers
        Castro Valley,
        California


        Comment


        • #5
          I saw that and almost hit the BIN, but noticed the same thing. It sounds like a repair panel, not a complete quarter panel.
          Don Wilson, Centralia, WA

          40 Champion 4 door*
          50 Champion 2 door*
          53 Commander K Auto*
          53 Commander K overdrive*
          55 President Speedster
          62 GT 4Speed*
          63 Avanti R1*
          64 Champ 1/2 ton

          * Formerly owned

          Comment


          • #6
            They look kinda wavy at the top of the wheel opening.

            Comment


            • #7
              Got a reply from vendor confirming it is a patch panel.
              Don Wilson, Centralia, WA

              40 Champion 4 door*
              50 Champion 2 door*
              53 Commander K Auto*
              53 Commander K overdrive*
              55 President Speedster
              62 GT 4Speed*
              63 Avanti R1*
              64 Champ 1/2 ton

              * Formerly owned

              Comment


              • #8
                Could just be the photo......but those panels sure are scary looking!

                Comment


                • #9
                  Very misleading advertising. I don't think I saw anything about a patch panel.

                  Comment


                  • #10
                    You an tell that it a half panel by the height of it. Looks like it would take a lot of hammer and dollie work to get it even ready for mud work. Has to be a real cheap built china panel.

                    Comment


                    • #11
                      Originally posted by swvalcon View Post
                      You an tell that it a half panel by the height of it. Looks like it would take a lot of hammer and dollie work to get it even ready for mud work. Has to be a real cheap built china panel.
                      The way I see it is that its a start in the right direction,China or not I hope it leads to better panels and then to full fenders.

                      Comment


                      • #12
                        The image only shows one panel patch. The second one is the image copied and flipped, imperfections and all.
                        Andy
                        62 GT

                        Comment


                        • #13
                          It looks like it would only need a few more inches on it to make it a full height panel. I presumed the rest of it disappeared becasue of the angle. So close, but its difficult to tell if the panel is accurate as others have mentioned.

                          Comment

                          Working...
                          X