Notice anything funny?

[Sdude]

This is our newest member's new (to them) 54 Commander. Jim asked me if I noticed anything funny about the front bumper. After he said that, it only took a second to see what he was talking about.

Shouldn't be too hard to fix.

[kurtruk]

Upside down. Reversed right-to-left?

EDIT: Of course, some would say, "Them fog lights just don't belong on there. Messes up a very clean design." Some would say.

[Lou Van Anne]

I agree with Some...is he in our chapter?

[SN-60]

Nice looking '54 coupe....looks like someone added an early '53 hood ornament?

[55s]

Wrong Bumperettes. Should be smaller. Those are typically 55 and up.

The foglights may be correct - the curve appears to fit the bumper.

Bumperettes in middle, fogs on outside.

[50starlite]

Looks like a 1955 Speedster setup to me. If he dosn't like it's an easy fix, or not.

Dick

[raoul5788]

Wrong Bumperettes. Should be smaller. Those are typically 55 and up.

The foglights may be correct - the curve appears to fit the bumper.

Bumperettes in middle, fogs on outside.

The larger bumperettes are correct for '54.

[kurtruk]

I agree with Some...is he in our chapter?

Every chapter has Some.

[rockne10]

The vertical bumpers are correct for '54. They would normally be inboard. With the fog lights mounted correctly inboard the vertical bumpers are correct outboard. The bumper is upside down. The angle on the ends should match the wheel opening; an easy fix.

[Milaca]

This will be VERY difficult to fix considering that you need to remove the body from the frame, flip the frame right-side up, and then re-attach the body to the frame. Good luck with this endeavor.

[Sdude]

Nice looking '54 coupe....looks like someone added an early '53 hood ornament?

That's correct too. He's looking for the correct hood ornament.

And he IS in our chapter, Lou. He also lives in Dixon.

[BobGlasscock]

This will be VERY difficult to fix considering that you need to remove the body from the frame, flip the frame right-side up, and then re-attach the body to the frame. Good luck with this endeavor.

Milaca, you forget one very important item in your process. After following your instructions, I am pretty sure that the rear bumper will now be upside down.

[Sdude]

So, I'm confused. Do the foglights belong on the inside of the bumperguards or should they be switched around?

[rockne10]

Fog lights should be inboard. In the absence of fog lights, the vertical bumpers would be inboard.

[johnod]

This will be VERY difficult to fix considering that you need to remove the body from the frame, flip the frame right-side up, and then re-attach the body to the frame. Good luck with this endeavor.

^^^^^ What he said.